EVO Recessed Wall Mount Installation Instructions
PM0437-03
EVO RECESSED WALL MOUNT INSTALLATION INSTRUCTIONS
PAGE 1 OF 2
EVO Recessed Wall Mounting
CONTENTS:
QTY PART
#
DESCRIPTION
1 MW0804-01
BOTTOM
TOWER
COVER
4
HW4559-03
1/4 – 20 x. 50L PAN HEAD PHILLIPS MACHINE SCREW
1
PM0432-01
COIN EVO MOUNTING TEMPLATE
1
PM0433-01
BILL EVO MOUNTING TEMPLATE
NOTE: THIS INSTALLATION SHOULD ONLY BE PERFORMED BY A QUALIFIED SERVICE TECHNICIAN.
To mount the EVO recessed in a wall follow the instructions below.
WARNING: Before cutting the hole for the EVO, make sure that there are no electrical
wires, pipes or supporting structures behind the wall in the location where you are
mounting the game. To install the game using this mounting option, there must be a
MAXIMUM amount of 4 inches of clearance space behind the wall with the cutout and
the supporting structure behind the wall where the game will be secured (see Figures 5A and 5B).
This supporting structure must be capable of supporting the weight of the game (the EVO with
coin is 85 pounds, the EVO with bill acceptor only is 75 pounds) and it must not be a load-bearing
wall. Follow all appropriate precautions while performing this installation.
EVO with Coin:
If you are installing the EVO on the wall, a quick adjustment to the coin mech is
required for proper operation of the mech. Follow the instructions below to adjust the coin mech
before continuing with the installation instructions. For EVOs with bill acceptors only, continue
with the installation instructions on the reverse side of this sheet.
1. Unlock and open the cash tower.
2. Using Figure 1 as a guide, pull the bottom tabs on the coin mech out of the back notch on the coin
mech bracket and place the bottom tabs on the coin mech in the front notch on the bracket. The top
tabs should remain in the back notch.
3. Close and lock the cash tower and continue with Recessed Wall Mount Installation Instructions on the
reverse side of this sheet.
NOTE: If you change the mounting of the EVO to table or bar top mounting, you must return the
coin mech to its original position.
FIGURE 1 - PROFILE OF COIN MECH BRACKET
BAR
MOUNT
WALL
MOUNT